Dürkopp Adler D888 e-con Operating Instructions Manual page 230

Code Type
9310 Error
9320 Error
9330 Information Material thickness sensor
9340 Information Remaining thread monitor
9341 Information Bobbin control (left) not
9350 Error
9351 Error
9352 Error
9353 Information Needle thread tension sen-
9354 Error
9360 Error
9361 Error
228
Possible cause
Tape feeder not connected
Tape feeder in lowered
position
not connected
not connected
connected
Upper machine head pcb is
not connected
Lower machine head pcb is
not connected
Right thread tension pcb is
not connected
sor pcb not connected
Needle Transport PCB not
connected
Edge guide pcb is not
connected
Edge guide x-axis pcb is not
connected
Corrective
• Check connection cables
• Perform software update
• Replace the control of the tape feeder
• Tape Feeder not in lowered position
• Check connection cables
• Perform software update
• Replace material thickness sensor
• Check connection cables
• Perform software update
• Replace remaining thread monitor
• Check connection cables
• Perform software update
• Replace remaining thread monitor
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace thread tension sensor
• Check connection cables
• Perform software update
• Replace needle transport PCB
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace PCB
Operating Instructions D888 e-con - 00.0 - 12/2023
Troubleshooting