Dürkopp Adler D888 e-con Operating Instructions Manual page 151

Programming Commander DELTA
Icon Parameter
Sewing foot lift at stop
Height of sewing foot lift at stop
Backwards
When the parameter is activated,
the section is sewn backwards.
Center guide
(only on two-needle machines, optional
additional equipment)
Puller
(optional additional equipment)
The puller supports the transport of the
sewing material. The feed of the two rollers
is calculated automatically based on the
stitch length of the machine. An adjustment
may be necessary depending on the
application.
The puller can be adjusted separately.
The input is in percent: a positive value
increases the roller feed while a negative
value reduces the feed.
Gap
(optional additional equipment)
The edge guide helps to precisely position
the sewing material. The value set indicates
the distance between the needle and edge
guide/material edge.
Light barrier
(optional additional equipment)
The light barrier detects the beginning
and the end of the material. After a signal
was detected, sewing can continue
automatically with the specifically set
parameters.
Thread tension sensor mode
(Access only after activation in
the machine configuration
Operating Instructions D888 e-con - 00.0 - 12/2023
Settings
Value range
On/Off
Value range
01 – 20 [mm]
(depending on subclass)
Value range
On/Off
Value range
On/Off
On/Off
Correction top roller
Value range
-100 – 100 [%]
Correction bottom roller
Value range
-100 – 100 [%]
Value range
08.0 – 45.0 [mm]
Value range
On/Off
( p. 152)
( p. 153)
149