Dürkopp Adler D888 e-con Operating Instructions Manual page 208

Code Type
1004 Error
1005 Error
1006 Error
1007 Error
1008 Error
1010 Error
1011 Error
1012 Error
1054 Error
1055 Error
1060 Error
206
Possible cause
Incorrect sewing motor
direction of rotation
Motor blocked
Maximum speed exceeded
Error in the reference run
Encoder error
External synchronizer plug
X5T (Sub-D, 9-pin) not
connected
Encoder Z pulse missing
Synchronizer fault
Internal short circuit
Sewing motor overload
Sewing motor overload /
overvoltage /overcurrent
Corrective
• Replace encoder
• Check motor plug assignment and
change it if necessary
• Check wiring in machine distributor and
change it, if necessary
• Measure motor phases and check for
value
• Check for stiff movement
• Replace encoder
• Replace sewing motor
• Replace encoder
• Carry out a reset
• Check class (t 51 04)
• Replace encoder
• Check for stiff movement
• Replace encoder
• Connect cable of external synchronizer to
control, make sure that interface (Sync) is
correct
• Only recommended for machines with
transmission!
• Switch off the control, use handwheel to
turn, and switch on the control again
• If error is not corrected, check encoder
• Replace synchronizer
• Replace the control
• Check for stiff movement
• Replace encoder
• Replace sewing motor
• Check selection of class
• Replace the control
• Replace motor
• Replace encoder
Operating Instructions D888 e-con - 00.0 - 12/2023
Troubleshooting