Dürkopp Adler D888 e-con Operating Instructions Manual page 210

Code Type
1302 Error
1330 Error
2101 Error
2105 Error
2121 Error
2122 Error
2130 Error
2131 Error
2152 Error
2171 Error
2172 Error
2173 Error
2174 Error
208
Possible cause
Failure with sewing motor
current
No response from sewing
motor
Stepper card X30 reference
drive timeout
Stepper card X30 blockage
Stepper card X30 encoder
plug (Sub-D, 9-pin) not
connected
Stepper card X30 flywheel
position not found
Stepper card X30 not
responding
Stepper card X30
initialization failure
Stepper card X30
overcurrent
Stepper card X30 watchdog
(Stitch length)
Stepper card X30 motor
overload / overvoltage /over-
current (Stitch length)
Stepper card X30 sewing
motor encoder not connected
(Stitch length)
Stepper card X30 sewing
motor encoder not initialized
(Stitch length)
Corrective
• Check Service Stop
• Check for stiff movement
• Replace encoder
• Replace motor
• Perform software update
• Replace the control
• Check reference sensor
• Check for stiff movement
• Connect encoder cable to the control, use
correct connection
• Check stepper motor 1 for stiff movement
• Perform software update
• Replace the control
• Perform software update
• Check selection of class
• Check for stiff movement
• Perform software update
• Check selection of class
• Check selection of class
• Replace the control
• Replace encoder
• Replace stepper motor
• Replace the control
• Perform software update
• Check selection of class
Operating Instructions D888 e-con - 00.0 - 12/2023
Troubleshooting