Canceling A Program In Automatic Mode; Using Programming Mode - Dürkopp Adler D888 e-con Operating Instructions Manual

122
5.8.2

Canceling a program in Automatic mode

To cancel a program in Automatic mode:
1. Press the pedal fully back.
 The program is canceled and the thread cut. The machine
takes note of where the program was canceled, and then
continues from the same point when sewing resumes.
2. To cancel the program completely, press the pedal all the way
backwards again.
 The program is canceled, and the machine starts from the first
seam section in the program when sewing resumes.
Important
Canceling by pedal is only possible if the parameter segment
switch by pedal is NOT active in the program defaults at the
Technician level.
If the parameter is still active, you can cancel the program only by
pressing the cross on the control panel.
5.9

Using Programming mode

Programming mode allows you to create new programs and copy
and adjust existing programs.
To access Programming mode:
1. Press the symbol
 This opens the navigation interface.
Programming Commander DELTA
to bring up the navigation pane.
Operating Instructions D888 e-con - 00.0 - 12/2023