Dürkopp Adler D888 e-con Operating Instructions Manual page 128

Icon Parameter
Sewing foot lifted
This function is used to lift the sewing
foot automatically. If the function is
executed within the seam segment,
the automatic sewing foot lift refers
to the sewing stop. Otherwise,
the function refers to the seam seg-
ment end, e.g. after thread cutting.
Thread trimmer active
Button to enable/disable the thread
trimmer
Needle thread clamp
Can only be adjusted before the first
stitch of a segment.
Fullness type
Switch between top and bottom full-
ness type.
Backwards
Stitches in segment will be sewn
backwards.
Can only be adjusted before the first
stitch of a segment.
Gap
(optional additional equipment)
Gap of motor driven edge guide to the
needle, considering the defined safety
clearance to the sewing feet.
126
To exit Teach-In:
1. Cut off the threads.
 A window for exiting the program is displayed:
• Discard seam: The window closes and the started seam is
reset.
• Append seam: The started seam is stored and a new seam
is appended.
• Finish teach: The program is saved and teach-in is fin-
ished.
Programming Commander DELTA
Setting
Value ranges
On/Off
Setting the Segment parameters
( p. 114)
Setting the Seam End parameters
( p. 115)
Value ranges
On/Off
Value ranges
On/Off
Value range
Top/Bottom
Value ranges
On/Off
Value ranges
On/Off
Operating Instructions D888 e-con - 00.0 - 12/2023