Dürkopp Adler D888 e-con Operating Instructions Manual page 149

Programming Commander DELTA
Icon Parameter
First bartack section
st
The 1
programmed with a different number of
stitches. All subsequent sections have
the preset number of stitches from
the settings for the start bartack.
Last bartack section
The last section of the bartack can be
programmed with a different number of
stitches. All previous sections have
the preset number of stitches from
the settings for the start bartack.
Invert bartack direction
Normally, a bartack starts either with the
sewing direction (forwards – even number
of sections) or against the sewing direction
(backwards – odd number of sections),
depending on the number of sections.
Setting this parameter inverts the sewing
direction of the bartack.
Operating Instructions D888 e-con - 00.0 - 12/2023
section of the bartack can be
5.9.6.1 Scan Mode
Before a chip can be read and stored for the first time, you must
select Read & Store.
To check if the chip is the chip that has been stored, you must
select Read & Compare.
Different messages may be displayed during the scan process/
sewing:
• Scan required: Please scan the RFID tag.
• Scan required: Please scan the same RFID tag again.
• Scan again as RFID tags did not match: The Read & Compare
found that the chips did not match. Please scan the same
RFID tag as before.
Another scan required: Please scan the same RFID tag again.
Settings
On/Off
Number of stitches
Value range
01 – 50 [stitches]
On/Off
Number of stitches
Value range
01 – 50 [stitches]
Value range
On/Off
147