Dürkopp Adler D888 e-con Operating Instructions Manual page 212

Code Type
2205 Error
2221 Error
2222 Error
2230 Error
2231 Error
2252 Error
2271 Error
2272 Error
2273 Error
2274 Error
2275 Error
2276 Error
2277 Error
210
Possible cause
Stepper card X40 stepper
motor blockage
Stepper card X40 encoder
plug (Sub-D, 9-pin) not
connected
Stepper card X40 flywheel
position not found
Stepper card X40 not
responding
Stepper card X40 initializa-
tion failure
Stepper card X40
overcurrent
Stepper card X40 watchdog
(Foot lifting)
Stepper card X40 motor
overload/overvoltage/over-
current (Foot lifting)
Stepper card X40 sewing
motor encoder not con-
nected (Foot lifting)
Stepper card X40 sewing
motor encoder not initialized
(Foot lifting)
Stepper card X40 init position
not found (Foot lifting)
Stepper card X40 not
enabled (Foot lifting)
Stepper card X40 I²t
(Foot lifting)
Corrective
• Check for stiff movement
• Connect encoder cable to the control, use
correct connection
• Check stepper motor 1 for stiff movement
• Perform software update
• Replace the control
• Perform software update
• Check selection of class
• Check for stiff movement
• Perform software update
• Check selection of class
• Check selection of class
• Replace the control
• Replace encoder
• Replace stepper motor
• Replace the control
• Perform software update
• Check selection of class
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace the control
• Check for stiff movement
• Replace encoder
• Replace motor
Operating Instructions D888 e-con - 00.0 - 12/2023
Troubleshooting