Dürkopp Adler D888 e-con Operating Instructions Manual page 232

Code Type
9924 Warning
9925 Warning
9926 Warning
9927 Warning
9928 Warning
9929 Warning
9930 Warning
9931 Information Bobbin Wind mode
9932 Information No program available
9933 Information Continue with actual value? • Shall the bobbin winder continue with the
9934 Warning
9935 Warning
9936 Warning
9937 Warning
9938 Warning
9939 Warning
9940 Information Teach finished?
9941 Information Empty bobbin right
230
Possible cause
Security key generated
Security Key changed!
Please Confirm Reset
Reset
Referencing?
Not enough thread available • Please insert a full bobbin
Empty bobbin
Tilt sensor active
Right bobbin cover
Left bobbin cover
Needle area cover
ENG ON 4
Tilt sensor active
Corrective
• Creation of a security key on a USB key
• Overwrite Security Key?
• Really reset?
• Reset successfully
• Press pedal backwards (pedal position-2)
• Please insert a full bobbin
• Press pedal backwards exit bobbin wind
mode
• Automatic mode is not available without a
program. Please use programming mode
to define a program.
actual value (Press YES), or shall the
bobbin winder restart with a new bobbin
(Press NO)?
• Tilt sensor active
• Right bobbin cover is open (ENG ON 1)
• Left bobbin cover is open (ENG ON 2)
• Needle area cover is open (ENG ON 3)
• (ENG ON 4)
• Tilt sensor active
• To finish the teach please press pedal -2
Low hook thread quantity
• The thread supply on the bobbin is nearly
used up. Please finish the seam and
replace the empty bobbin with a full one.
Please remove any remaining thread
from the bobbin prior to winding.
Operating Instructions D888 e-con - 00.0 - 12/2023
Troubleshooting