Table of Contents
Advertisement
110
5.7.3.4 Function modules
This parameter provides virtual switches that can be assigned
customer-specific functions. They can be used when customer-
specific applications require a signal from the control of the machine.
This parameter cannot be used unless the function modules have
been assigned to a physical output at the Technician level. This
requires that the parameter Module management be configured at
the Technician level; for more details, refer to the explanation in
the ( Service Instructions).
It is possible for each function module to place one function tile
(stored) on the main screen ( p. 89).
Menu item
Setting 1
Function modules 1 – 8
Material thickness
Only visible in the mode
Material thickness.
The function module
becomes active starting with
the entered limit.
5.7.3.5 Setting the Output parameter
This parameter provides virtual outputs that can be assigned
customer-specific functions. They can be used when customer-
specific applications require a signal from the control of the
machine.
This parameter cannot be used unless the virtual outputs have been
assigned to a physical output at the Technician level. This requires
that the parameter Additional I/O Configuration be configured at
the Technician level; for more details, refer to the explanation
( Service Instructions).
Programming Commander DELTA
Operating Instructions D888 e-con - 00.0 - 12/2023
Setting 2
Value range
Material thickness/input
Value range
00 – 10 [rpm]
(depending on subclass)
Advertisement
Table of Contents
