Dürkopp Adler D888 e-con Operating Instructions Manual page 53

Operation
Operating Instructions D888 e-con - 00.0 - 12/2023
Status Processes
At seam beginning
Backtacking • Press the pedal forwards (position +1) and keep it
and sew there.
Machine sews a start bartack (if specified).
Afterwards, the machine continues to sew – with
increasing speed the further forward the pedal is
pressed.
In the middle of the seam
Stop sewing • Release the pedal (position 0).
The machine stops. Depending on the setting,
the roller foot is either up or down.
Continue • Press the pedal forwards (position +1)
the sewing Machine continues to sew – with increasing speed
process (after the further forward the pedal is pressed.
releasing the
pedal)
Sewing over • Use the knee button to increase the roller foot stroke
thicker parts ( p. 46).
of the material
Changing the
• Activate the 2
stitch length
push button panel ( p. 46).
Increasing the • Use the button on the push button panel to activate
thread tension the additional thread tension ( p. 46).
Sewing an • Sew backwards with stitch regulator ( p. 46) or
intermediate activate backwards sewing using the button on the
bartack push button panel ( p. 46).
At seam end
Finish the • Press the pedal fully back (position -2) and keep it
seam and there.
remove End bartack is sewn, and thread is cut (if set).
the sewing Machine stops.
material Needle is up. Roller foot is up.
• Remove the sewing material.
nd
stitch length using the button on the
51