Table of Contents
Advertisement
Icon
Parameter
Stitch length default
If this function is active, the same needle
stitch length is used for the bartack as
the one set in Manual mode. If this
function is deactivated, a custom input
can be entered.
Sewing speed
Single stitches per pedal
If this function is activated, each stitch in
the bartack can be sewn individually by
pressing the pedal. This function can only
be used meaningfully if the speed is set very
low for the bartack.
Needle thread tension default
If this function is active, the same needle
thread tension is used for the bartack as
the one set in Manual mode. If this
function is deactivated, a custom input
can be entered.
Catch bartack
To ensure a safe sewing start and
complete sewing of the start bartack,
an additional bartack can precede
the start bartack.
Only the number of forward and backward
stitches can be selected. The stitch length
cannot be set individually – it corresponds
to the stitch length of the normal start
bartack.
146
Programming Commander DELTA
Settings
On/Off
Stitch length of backwards stitches
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Stitch length of stitches forward
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Value range
0050 – 2000 [rpm]
Value range
Off
With bartack speed
With pedal speed
Value range
On/Off
On/Off
Number of stitches backwards
Value range
01 – 50 [stitches]
Number of stitches forward
Value range
01 – 50 [stitches]
Number of
bartack sections
Value range
01 – 10
Operating Instructions D888 e-con - 00.0 - 12/2023
Advertisement
Table of Contents
