Dürkopp Adler D888 e-con Operating Instructions Manual page 39

Operation
Operating Instructions D888 e-con - 00.0 - 12/2023
Fig. 19: Winding the hook thread (2)
④
⑤
(4) - Winder lever
(5) - Bobbin shaft
7. Guide the thread to the winder (7).
8. Clamp the thread behind the knife (6) and tear off the loose
end behind it.
9. Fit the bobbin on the bobbin shaft (5).
10. Turn the bobbin on the bobbin shaft (5) until the drive dog
spring audibly clicks into place in the slot of the bobbin.
11. Pull the winder lever (4) up.
 The winding process starts and ends automatically when the
bobbin is full. The winder lever (4) returns to its lower position.
Information
The hook thread is normally wound on when sewing is in progress.
However, you can also wind on the hook thread without sewing,
e. g. if you require a full bobbin in order to start sewing. For this
purpose, use Bobbin Wind mode in Manual mode ( p. 118).
12. Pull off the full bobbin.
13. Tear off the thread behind the knife (6).
14. Insert the full bobbin into the hook ( p. 38).
(6) - Knife
(7) - Winder
⑦
⑥
37