Dürkopp Adler D888 e-con Operating Instructions Manual page 231

Troubleshooting
Code Type
9362 Error
9370 Warning
9371 Warning
9372 Warning
9910 Warning
9911 Warning
9912 Warning
9913 Warning
9914 Warning
9915 Warning
9916 Warning
9917 Warning
9918 Warning
9919 Warning
9920 Warning
9921 Warning
9922 Warning
9923 Warning
Operating Instructions D888 e-con - 00.0 - 12/2023
Possible cause
Edge guide y-axis pcb is not
connected
Scanner module not
connected
Scanner module 24 V Error
Scanner module 5 V Error
Sewing stop
Power down
Restart necessary
Empty bobbin
Reset
Please Wait!
Erase internal Memory
Erase USB key
No USB key present
Sewing stop
Referencing
Show Message from
QONDAC
Service Stop
Update required
Corrective
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace scanner module
• Check connection cables
• Check connected scanners
• Replace scanner module
• Stored analogue value for stroke
• Check tilt sensor on machine
• Check 24V
• Replace the control
• The control is switched off
• Switch off the control
• Please insert a full bobbin
• Remove USB key!
• Please wait and do not remove USB key
• Delete the SD card. Continue with OK;
cancel with ESC
• Delete the USB key. Continue with OK;
cancel with ESC
• Please insert USB key
• Machine in stop mode for threading
the thread
• Please wait for motor referencing
• Show Message
• Check the Service Stop button
• Check 24V
• Replace the control
• Press OK for Restart or ESC for cancel
229