For Two-Needle Machines - Dürkopp Adler D888 e-con Operating Instructions Manual

Operation
Operating Instructions D888 e-con - 00.0 - 12/2023
14. Pull the thread through the needle eye (15) in such a way that
the loose thread end has a length of approx. 4 cm with the
thread lever (9) at the highest position.
Important:
Check the thread length.
If the loose thread end is too long, the thread may be caught by
the hook and cause a disturbance. If the loose thread end is too
short, the machine cannot start sewing.
4.5.2

For two-needle machines

Fig. 11: Threading the needle thread (two-needle machine) (1)
①
(1) - Tube
To thread the right and the left needle thread:
1. Fit the thread reels on the reel stands.
The unwinding bracket must stand directly above the thread
reels.
2. Feed the left thread from the rear to the front through the thread
guide (2) on the unwinding bracket.
3. Feed the right thread from the rear to the front through the
thread guide (2) on the unwinding bracket.
(2) - Thread guide on the unwinding
bracket
②
29