Table of Contents
Advertisement
Programming Commander DELTA
Operating Instructions D888 e-con - 00.0 - 12/2023
Menu item
Software / Stitch Counter
In Software mode, the
bobbin is monitored by
the software based on
the number of stitches
sewn.
Setting 1
Counter Type
4 different counters can be
applied. The following 3
sub-items can be set for
each of the counters.
Counter value
Bobbin supply capacity in
stitches. This is a very
variable value, which
depends on the size of the
bobbin and the thickness of
the thread.
Sewing stop
Sewing stops and a notice is
shown on the display when
the bobbin is detected to be
nearly empty. If the
parameter is not activated,
only the LEDs on the
machine arm give a warning
if the bobbin is empty.
Sewing foot lower position
Reset necessary
It is only possible to resume
sewing after changing
the bobbin and confirming
the message on the control
panel.
Setting 2
Value range
A/B/C/D
Value range
00000 – 99999
[stitches]
Value range
On/Off
Value range
On/Off
Value range
On/Off
135
Advertisement
Table of Contents
