Dürkopp Adler D888 e-con Operating Instructions Manual page 229

Troubleshooting
Code Type
8232 Error
8251 Error
8258 Error
8259 Error
8282 Error
9230 Warning
9240 Warning
9241 Warning
9300 Error
Operating Instructions D888 e-con - 00.0 - 12/2023
Possible cause
Stepper card parameter
initialization (Edge guide)
Stepper card reference drive
timeout (Edge guide)
Stepper card not responding
(Edge guide)
Stepper card initialization
failure (Edge guide)
Stepper card parameter
initialization (Edge guide)
No thread detected
No thread tension sensor
detected (right)
No thread tension sensor
detected (left)
CAN cable not connected
Corrective
External Edge guide X Axis
• Perform software update
• Check selection of class
External Edge guide Y Axis
• Check reference sensor
External Edge guide Y Axis
• Perform software update
• Replace the control
External Edge guide Y Axis
• Perform software update
• Check selection of class
External Edge guide Y Axis
• Perform software update
• Check selection of class
• Check the thread
• Check connection cables
• Replace sensor
• Check sensor
• Check connection cables
• Replace thread tension sensor
• Check sensor
• Check connection cables
• Replace thread tension sensor
• Check CAN cable
• Switch off the machine and disconnect all
CAN devices (including SSD!) from the
control, except for the lower machine
head PCB
• Check if an error message other than
9300 is displayed
• If an error message other than 9300 is dis-
played, switch off the machine, reconnect
another CAN device and check again
• If error message 9300 is displayed again,
it is most likely that the device connected
last is faulty
• Repeat the process until all devices are
connected again
227