Dürkopp Adler D888 e-con Operating Instructions Manual page 234

Code Type
9955 Warning
9956 Warning
9957 Warning
9958 Warning
9961 Warning
9962 Warning
9963 Warning
9964 Warning
9965 Warning
9966 Warning
9967 Warning
9968 Warning
9969 Warning
232
Possible cause
Desk positioning Timeout
Desk Height Sensor Error
Height limit control active
A function of the Perfect
Quality Sensor (PQS) is
active
Material thickness above
maximum limit
Material thickness below
minimum limit
Please Wait!
Edge Guide in Wrong
Position
Select target position
Thread Tension too low
(Warning)
Edge Guide in Wrong
Position
PQS not connected
Thread Tension too high
(Warning)
Corrective
• A timeout occurred during positioning.
• If the desk is not positioned at its minimum
or maximum height, check if it is blocked
The sensor for the desk height measurement
is not responding or transmits a faulty signal.
The height adjustment is not possible.
• Check cable connections
• Check if the sensor is switched on
• The height cannot be adjusted until the
error has been corrected and the
machine has restarted
• Height limit control active
• A function of the Perfect Quality Sensor
(PQS) is active. Therefore the lifting
height or the needle position could
change automatically.
• The current material thickness exceeds
the maximum permissible limit.
• The current material thickness falls below
the maximum permissible limit.
• Please wait for the ongoing operation to
be finished
• Edge Guide must be in the right position
• Select target position
• Thread Tension too low (Warning)
• Edge Guide must be in the right position
• PQS is activated but not connected,
please check the connection to the PCB
or call the DA service
• Thread Tension too high (Warning)
Operating Instructions D888 e-con - 00.0 - 12/2023
Troubleshooting