Programming
19.2.5 Setting the multiple end bartack
Use the multiple end bartack to set the number of stitches as well as the
number of repetitions.
To set the multiple end bartack:
1. Press
The LED flashes.
2. Press the C+ button from the Programming button group repeatedly
3. Press the D+ button repeatedly until the required number of backward
4. Press the A+ button repeatedly until the required number of repetitions
5. Confirm your selection with
You can begin sewing; press the pedal forward to pedal position +1.
At the end of the seam, press the pedal back to pedal position -2.
19.2.6 Activating the thread cutter
The thread cutter automatically cuts the thread at the seam end.
To activate the thread cutter:
1. Press
The LED illuminates.
19.2.7 Activating the thread clamp
The thread clamp holds the thread firmly to pull it down and loop it while
sewing on.
To activate the thread clamp:
1. Press
The LED illuminates.
Service Instructions 1767 - 00.0 - 12/2016
.
until the required number of forward stitches is reached.
stitches is reached.
is reached.
.
.
.
99