Dürkopp Adler D888 e-con Operating Instructions Manual page 99

Programming Commander DELTA
Icon Parameter
Bobbin monitor mode
Point position
The distance of the needle from the mate-
rial can be adjusted to allow precise
positioning of the sewing material when
starting sewing.
The value entered corresponds to the
degree number on the handwheel.
Gap
Value for the gap between the motor-driven
edge guide and the needle (factoring in the
defined safety distance to the sewing feet).
Flat Sew
Transport correction at zero difference for
Flat Sew.
Material thickness detection
Material thickness detection
Stitch length
Needle thread tension
Sewing foot pressure
Max. Speed
Operating Instructions D888 e-con - 00.0 - 12/2023
Settings
( p. 99)
Value range
000 – 359 [°]
Value range
08.0 – 45.0 [mm]
(depends on the sewing equip-
ment)
Value range
-20 – 20
Value range
On/Off
( p. 101)
The stitch length changes slightly
depending on the material
thickness. For this reason, the
stitch length can be adjusted to
different material thicknesses by
the software.
Depending on the material thick-
ness, the needle thread tension
can be adjusted to different mate-
rial thicknesses by the software.
The sewing foot pressure can be
adjusted at different material thick-
nesses by the software.
The maximum sewing speed can
be adjusted to different material
thicknesses by the software.
97