Installing The System Board Assembly - HPE ProLiant MicroServer Gen10 Plus v2 User Manual

IMPORTANT: IMPORTANT:
The storage cables connect the system board to the chassis. If you are completely separating the system board assembly The storage cables connect the system board to the chassis. If you are completely separating the system board assembly
from the chassis, from the chassis, disconnect the storage cabling disconnect the storage cabling . .
9. Use the blue touchpoints on both sides of the tray to pull out the system board assembly from the chassis.

Installing the system board assembly

Installing the system board assembly
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. If the storage cables were removed, reconnect the cables.
2. Install the system board assembly:
a. Slide the system board assembly into the chassis (callout 1).
b. Install the system board assembly screws (callout 2).
HPE ProLiant MicroServer Gen10 Plus v2 User Guide 33