Installing An Expansion Card On The System Board - HPE ProLiant ML110 Gen11 User Manual

13. Install the access panel .
14. Do one of the following:
Orient the server back to tower mode.
Install the server into the rack.
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server.
Results Results
The installation is complete.
Expansion card options Expansion card options
The server supports the installation of full-height, full-length, and full-height, half-length PCIe expansion / add-in (AIC) cards such as:
HPE type-p storage controller
Ethernet adapter
HDR InfiniBand adapter
Accelerator (workload, computational, or graphics accelerator)
For more information on the expansion options supported by the server, see the server QuickSpecs on the Hewlett Packard Enterprise
website:
https://buy.hpe.com/us/en/p/1014705725 https://buy.hpe.com/us/en/p/1014705725
Subtopics Subtopics

Installing an expansion card on the system board

Installing an expansion card on the system board
Installing an expansion card in the riser cage Installing an expansion card in the riser cage
Installing an expansion card on the system board Installing an expansion card on the system board
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCIe slots have either a CAUTION:
riser slot blank or an expansion card installed.
CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static- CAUTION:
sensitive devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
HPE ProLiant ML110 Gen11 Server User Guide 136