Table of Contents
Advertisement
7700 MultiFrame Manual
7760VMS-HD HD Video Monitoring Splitter
6.
CARD EDGE MENUS
6.1.
NAVIGATING THE CARD EDGE MENU SYSTEM
Status monitoring and control over the card's parameters is provided via the 4-digit alphanumeric display
located on the card edge. The toggle switch and pushbutton are used to navigate through a menu system
to set various parameters for the module. In Status mode the menu system provides status of the card
only. To enter the menu system, press the pushbutton. This will bring you to the main setup menu where
you can use the toggle switch to move up and down the list of available sub menus. Once you have
chosen the desired sub menu, press the pushbutton to select the next menu level.
Once you are in the sub menu, there will be a list of parameters to adjust. To adjust any parameter, use
the toggle switch to move up or down to the desired parameter and press the pushbutton. Using the toggle
switch, adjust the parameter to its desired value. If the parameter is a numerical value, the number will
increase if you lift the toggle switch and decrease if you push down on the toggle switch. If the parameter
contains a list of choices, you can cycle through the list by pressing the toggle switch in either direction.
When you have stopped at the desired value, depress the pushbutton. This will update the parameter to
the selected value and return to the sub menu. To change another parameter, press the pushbutton to
enter the main menu system again and continue selecting and adjusting other parameters.
Each of the menu items is described in the following sections, with an explanation of what each choice
does. Throughout the descriptions of the menu items, the default values are shown in underlined text.
6.2.
CARD EDGE SETUP MENU
The following is a brief description of the top level of the menu tree that appears when you enter the card
edge setup menu. Selecting one of these items will take you down into the next menu level. The details
of the each of the displays are described in the sections 6.2.1 to 6.2.8.
BACK
GTSD
VIDP
ASP1
PCL1
HSPL
VSPL
DISP
VER
Page - 10
Returns the display back to monitoring mode
Selects the genlock standard
Selects the behaviour of the monitor output when there is a loss of video
Selects the aspect ratio for monitor output
Selects the panel colours for monitor output
Sets the horizontal split line
Sets the vertical split line
Sets the orientation of the display
Display the firmware version number
Revision 0.3
Advertisement
Table of Contents
