Install The Server Top Cover - Oracle Exadata X10M Service Manual

Remove the PCIe slot filler panel.
3.
a.
b.
Install the PCIe slot filler panel.
4.
a.
b.

Install the Server Top Cover

Place the top cover on the chassis [1].
1.
Set the cover down so that it hangs over the back of the server by about 1 inch (25
mm) and the side latches align with the cutouts in the chassis.
Check both sides of the chassis to ensure that the top cover is fully down and flush
2.
with the chassis.
If the cover is not fully down and flush with the chassis, slide the cover towards the
back of the chassis to position the cover in the correct position.
Gently slide the cover toward the front of the chassis until it latches into place with
3.
an audible click [2].
As you slide the cover toward the front of the server, the release button on the top
of the server automatically rotates downward to the closed position. Latch the top
cover by pushing down on the button until it is flush with the cover and you hear an
audible click. An audible click indicates that the cover is latched.
Remove the server top cover.
To remove the PCIe slot filler panel, rotate the PCIe locking mechanism in to
an upright position, and lift and remove the PCIe slot filler panel where you
want to install the PCIe card.
Remove the server top cover.
Press the PCIe filler panel into the vacant PCIe slot, and rotate the PCIe
locking mechanism downward to secure the PCIe slot filler panel. You hear an
audible click when the PCIe filler panel is secured into the slot.
Chapter 17
Install the Server Top Cover
17-2