Oracle Exadata X10M Service Manual page 139

• Never remove the processor from the carrier. Replacement processors come with
a carrier package.
• Whenever you remove a processor on a usable motherboard, replace it with
another processor and reinstall the processor heatsink; otherwise, the server
might overheat due to improper airflow. See
Prepare the server for service.
1.
Power off the server.
a.
See Powering Down the
Disconnect the power cords from the power supplies.
b.
See Disconnect Cables From the
Extend the server to the maintenance position.
c.
See Extend the Server to the Maintenance
Attach an antistatic wrist strap to your wrist, and then to a metal area on the
d.
chassis.
See Take Antistatic
Remove the server top cover.
e.
Use a Torx T15 screwdriver to unlock the release button latch.
See Remove the Server Top
Remove the air baffle.
f.
Remove the air baffle (sitting over the two processors) by lifting the baffle up
and out of the server. Lift up the air baffle in the rear at a 50 degree angle, and
slide slightly rearward to clear the air baffle tabs that prevent the front of the
baffle from lifting up. Set aside the air baffle.
See Remove the Air
Identify the location of the failed processor by pressing the Fault Remind button on
2.
the motherboard.
Install a
Server.
Server.
Position.
Measures.
Cover.
Baffle.
Chapter 13
Identify and Remove a Processor
Processor.
13-4