Remove The 12-Drive Backplane - Oracle Exadata X10M Service Manual

b.
c.
d.
e.
f.
g.

Remove the 12-Drive Backplane

To remove the 12-Drive backplane (DBP):
Prepare the server for service.
1.
a.
b.
c.
d.
e.
f.
g.
See Install the Fan Tray.
Install the fan modules.
See Install a Fan Module.
Install the air baffle.
See Install the Air Baffle.
Install the server top cover.
See Install the Server Top
Return the server to the normal rack position.
See Return the Server to the Normal Rack
Reconnect the power cords to the power supplies, and power on the server.
See Reconnect Power and Data Cables
Verify that the power supply AC OK LED is lit.
Note:
IMPORTANT: When the disk backplane is replaced, the key identity properties
(KIP) of the backplane is programmed by Oracle ILOM to contain the same KIP
as the other quorum member components. If you removed other quorum
member components, you might need to manually program the product serial
number (PSN) into the new backplane. For more information, see
Identity Properties (KIP) Automated
Power off the server.
See Powering Down the Server.
Disconnect the power cords from the power supplies.
See Disconnect Cables From the
Extend the server into the maintenance position.
See Extend the Server to the Maintenance
Attach an antistatic wrist strap to your wrist, and then to a metal area on the chassis.
See Take Antistatic Measures.
Remove the server top cover.
See Remove the Server Top
Remove the air baffle.
See Remove the Air Baffle.
Remove the fan modules from the server.
See Remove a Fan Module.
Cover.
Position.
and Power On the
Update.
Server.
Position.
Cover.
Chapter 14
Remove the 12-Drive Backplane
Server.
FRU Key
14-5