Ethernet Device Naming - Oracle Exadata X10M Service Manual

Log in as a user with root or administrator privileges. For example: ssh root@
ipaddress Where ipaddress is the IP address of the server SP.
The Oracle ILOM CLI prompt (->) appears.
To set the serial port owner, type: -> set /SP/serial/portsharing
2.
owner=host
Connect a serial host to the server.
3.
Oracle ILOM web interface
Log in to the SP Oracle ILOM web interface.
1.
Open a web browser and direct it using the IP address of the server SP. Log in as
root or a user with administrator privileges.
On the Summary Information page, select ILOM Administration →
2.
Connectivity from the navigation menu on the left side of the screen.
Select the Serial Port tab.
3.
On the Serial Port Settings page, select Host Server as the serial port owner.
4.
Click Save for the changes to take effect.
5.
Connect a serial host to the server.
6.
For details, refer to

Ethernet Device Naming

This topic contains information about the device naming for the 1GbE 100/1000BASE-
T Gigabit Ethernet (GbE) port (labeled
Back Panel Connector Locations
The device naming for the Ethernet interface is reported differently by different
interfaces and operating systems. The following table shows the BIOS (physical) and
operating system (logical) naming convention for the interface. The device naming
convention might vary, depending on the conventions of your operating system and
which devices are installed in the server.
Note:
Naming used by the interfaces might be different from the names in the
following table, depending on which devices are installed in the system.
Note:
The serial port sharing value, by default, is owner=SP.
Note:
The serial port sharing setting, by default, is Service Processor.
Oracle ILOM Documentation.
and
Attaching Devices to the Server
NET 0) on the back panel of the server. See
Ethernet Port Status Indicators.
Chapter 2
2-12