Reset The Server Using Oracle Ilom; Log Out Of Oracle Ilom; Mouse Mode Properties - Oracle Exadata X10M Service Manual

Table 2-11
Operating Systems
Oracle Linux
Oracle VM
VMware ESXi Software
Windows Server
For more information about selecting a mouse mode, refer to Oracle ILOM
Administrator's Guide for Configuration and Maintenance in
Documentation.
To set the mouse mode, perform the following steps:
Log in to the Oracle ILOM web interface.
1.
See
Navigate to the Remote Control → KVMS page, and then select a mouse mode
2.
from the Mouse Mode drop-down list.
Click Save.
3.

Reset the Server Using Oracle ILOM

For more details, see
Log in to the Oracle ILOM web interface or command-line interface (CLI) using an
1.
account with admin (a) role privileges.
Reset the server:
2.
•
•
•

Log Out of Oracle ILOM

See the following procedure to log out of Oracle ILOM CLI or web interface.
•
To end an Oracle ILOM session:
•

Mouse Mode Properties

Log In to Oracle ILOM Using a Remote Ethernet
Controlling System Power
From Oracle ILOM CLI, type: -> reset /System. When prompted, type y
to confirm:
Are you sure you want to reset /System (y/n)? y
Performing hard reset on /System
From Oracle ILOM web interface, select Host Management → Power
Control, and in the Select Action list box, select Graceful Reset, Reset,
or Power On. Click Save, and then click OK.
From the local server, press the On/Standby button on the front panel of the
server for approximately 1 second to power off the server, and then press the
On/Standby button again to power on the server.
The power-on self-test (POST) sequence begins.
From the Oracle ILOM CLI – Type exit at the CLI prompt.
Mouse Mode
Absolute
Not applicable
Not applicable
Absolute
Oracle ILOM
Connection.
and Oracle ILOM
Chapter 2
Accessing Oracle ILOM
Documentation.
2-24