Oracle Exadata X10M Service Manual page 158

Reconnect the DBP power cable and the DBP auxiliary signal cable to the disk
b.
backplane [3].
Install the storage drive cage in to the chassis.
2.
Align the storage drive cage with the opening in the front panel of the server.
a.
Pull the attached DBP power cable and DBP auxiliary signal cable through the
opening while gently pushing the storage drive cage in to the chassis until it is
fully seated in the chassis [4].
Using a Torx T15 screwdriver, tighten the two spring-mounted screws to
b.
secure the storage drive cage to the chassis [5].
Gently insert the DBP auxiliary signal cable in to the left-side cable trough.
c.
Reconnect the DBP auxiliary signal cable and DBP power cable to the
motherboard connectors [6].
See also Install the Disk Backplane Signal
Reinstall the storage drives in to the front
d.
Reinstall all NVMe storage drives into the server front panel storage drive cage.
3.
See Install a Storage
Return the server to operation.
4.
Install the fan tray.
a.
Drive.
Install the 4-Drive Backplane
Cable.
Chapter 14
14-4