Remove A Pcie Riser - Oracle Exadata X10M Service Manual

Reconnect the cables to the PCIe card that you unplugged during the removal
6.
procedure.
If it is difficult to reconnect the cables to the PCIe card when the card is secured
into the PCIe slot, consider performing this procedure prior to inserting the PCIe
card in to the PCIe Riser slot.
Install the PCIe riser that contains the PCIe card.
7.
See

Remove a PCIe Riser

This task applies only to the back panel Riser configuration.
Prepare the server for service.
1.
a.
b.
c.
d.
e.
f.
Install a PCIe Riser.
Power off the server.
See Powering Down the Server.
Disconnect the power cords from the power supplies.
See Disconnect Cables From the
Remove rear panel cables.
See Full Height PCIe Configuration in
Using a Torx (6 lobe) T25 screwdriver, loosen the rear panel Riser(s) attaching
screw [2].
Extend the server into the maintenance position.
See Extend the Server to the Maintenance
Attach an antistatic wrist strap to your wrist, and then to a metal area on the
chassis.
See Take Antistatic Measures.
Server.
Back Panel Components.
Position.
Chapter 11
Remove a PCIe Riser
11-8