Function Menu; Touch Lock Key - Rigol MSQ7054 User Manual

RIGOL

Function Menu

Measure: Press this key to enter the measurement setting menu. You can set the
measurement source, enable or disable the all measurement function, the statistical
analysis function, and etc. You can make a quick measurement for 41 waveform
parameters.
Acquire: Press this key to enter the acquisition setting menu. You can set the time
base mode, the acquisition mode, memory depth, and etc.
Storage: Press this key to enter the file or waveform storage and load interface.
The file types for storage include image, waveform, and setups. Besides, waveform
load and setup load are supported. The disk management and file auto naming
function are also supported in this menu.
Cursor: Press this key to enter the cursor measurement menu. The oscilloscope
provides four cursor modes: Manual, Track, XY, and Measure. Note that XY cursor
mode is only available when the horizontal time base is set to "XY".
Display: Press this key to enter the display setting menu. You can set the display
type, persistence time, wave intensity, and etc.
Utility: Press this key to enter the system function setting menu. You can set
system-related functions or parameters, such as I/O, sound, language, and etc.
Besides, some advanced functions (such as the pass/fail test, waveform recording,
and self-calibration) are also supported.

Touch Lock Key

Press this key to disable the touch screen function.
Note: By default, the touch screen function of the oscilloscope is always enabled. If
you disable the function, press the key again to enable it.
1-20
Chapter 1 Quick Start
MSO7000/DS7000 User Guide