Table of Contents
Advertisement
15.8.3
Event Table
Open or Close the Event Table
Click or tap the Event Table on/off switch to enable or disable the display of the
event table. When enabled, the event table is displayed as shown in the figure below.
You can also click or tap the icon
the event table.
TIP
•
When you adjust the horizontal time base, the waveform displayed on the screen will also
change, and the total number of lines containing the decoding information in the event
table will also be changed.
•
The displayed decoded data information in the bus is related to the value of the
horizontal time base. Reducing the horizontal time base can help you view the detailed
information.
Set the Event Table Format
In the Decode menu, click or tap the drop-down button of Format to select the
display format of "Data" in the event table. The available options include "Hex",
"Dec", "Bin", or "ASCII".
Interpret the decoded FlexRay frame data
•
TSS: transmission start sequence, identified as "TSS:".
•
Sync Frame: identified as "SYNC:".
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
at the upper-right corner of the table to close
Figure 15.23 FlexRay Decoding Event Table
Protocol Decoding
HDO4000 User Guide
221
Advertisement
Table of Contents
