To Set The Waveform Size; To Set The Order; Probe Calibration; Label Settings - Rigol DHO924S User Manual

12.4
12.5
12.6
12.7
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
1.888.610.7664

To Set the Waveform Size

In the menu as shown in
the waveform display size. Available options include "Small", "Medium", and "Large".
TIP
"Large" is available only when the number of currently enabled channels is not greater than 8.

To Set the Order

In the menu as shown in
select the waveform arrangement order for the currently enabled channels on the
display.
• D0-D15: the waveforms on the display are D0-D15 in sequence from top to
bottom.
• D15-D0: the waveforms on the display are D15-D0 in sequence from top to
bottom.
You can also drag the digital channel waveform in the waveform view to change the
order.

Probe Calibration

If the PLA2216 active logic probe is connected to the oscilloscope for the first time or
when the changes of the ambient temperature are above 5℃, it is recommended to
perform zero calibration for the probe. Make sure that no signal is applied to the
PLA2216 input terminal when the probe is under calibration.
Figure 12.1
In , click or tap ProbeCalibration to enter the "ProbeCalibration" menu.
Click or tap Start to start zero calibration automatically for the probe.

Label Settings

By default, the instrument takes D0-D15 as the channel label of the 16 digital
channels. You can set a user-defined label for each digital channel to easily
differentiate the digital channels.
In the LA menu, click or tap Label settings to enter the Label settings menu. You can
then use the preset label or input a label manually.
Label On/Off
Click or tap the Label Enable on/off switch to enable or disable the label display. If it
is on, the channel label will be displayed at the left side of the waveform.
www.calcert.com
15
10 20
5 25
0 30
Figure 12.1
, click or tap the Size drop-down button to select
Figure 12.1
, click or tap the Arrange drop-down button to
DHO900 User Guide
sales@calcert.com
163