Panasonic KX-NS300 Pc Programming Manual page 75

•
The USB memory device hardware is faulty.
•
The data on the USB memory device has become corrupted.
•
The USB memory device is removed from the USB port of the PBX during the restoration process.
•
The following characters cannot be used in the names of the backup files: open bracket, close
bracket, space, forward slash ("/"), period ("."), or 0 (zero).
To minimise the potential of a failed backup, connect the USB memory device to a PC to confirm the
USB memory device is operational and that the backup data is intact before starting this restore
process.
1.
The PBX must be in a powered-off state.
2.
Insert the USB memory device with the backup data into the USB port of the PBX.
3.
Set the PBX's System Mode Switch to the "SYSTEM INITIALIZE" position.
4.
Turn on the PBX's power switch. The STATUS indicator will flash green. Slide the System Mode Switch
back to the "NORMAL" position. The restore process will begin and the STATUS indicator will flash
rapidly.
5.
When the restoration process is completed, the PBX will restart automatically.
6.1.2 Tool—System Data Backup—Backup to NAS
A PBX's system data can be backed up to a NAS (Network Attached Storage) in the PBX's LAN network.
This screen can be accessed only in On-line mode.
To back up the system data to a NAS
1.
Connect a NAS and PBX.
Set the parameters necessary to connect the NAS to the PBX (IP address of the NAS, etc.), and then
confirm the connection. See 27.4.2 Network Service—[4-2] Other—NAS.
2.
Select the system data items to backup.
•
System Data
System data includes programming information for the PBX, including extension and network
configuration information.
•
MOH + OGM
MOH (Music on Hold) and OGM (Outgoing Message) sound files stored on the PBX are backed up.
3.
Click Execute to back up the specified files. If backup data already exists on the NAS, it will be
deleted. A confirmation message will be displayed. Click Continue.
4.
A progress bar is displayed to indicate the progress of the backup. A message will be displayed when
the backup is finished. Click OK.
Note
•
Unified Messaging (UM) data must be backed up using a separate process. See 6.9 Tool—UM Data
Backup.
•
Data backed up from the PBX to a NAS cannot be restored directly from the NAS to the PBX. The
backup data must be copied from the NAS to a local PC. Then the data can be restored from the local
PC to the PBX.
•
The following characters cannot be used in the names of the backup files: open bracket, close
bracket, space, forward slash ("/"), period ("."), or 0 (zero).
•
When using a NAS, make sure there is sufficient network bandwidth.
•
When using a NAS, select the protocol NFS (Ver.4 only) or CIFS. For more information, see
27.4.2 Network Service—[4-2] Other—NAS.
6.1.2 Tool—System Data Backup—Backup to NAS
PC Programming Manual 75