Panasonic KX-NS300 Pc Programming Manual page 28

1.2.1 Starting Web Maintenance Console
– http://kx-ns300.
Note
•
If entering "http://kx-ns300.", be sure to include the period at the end as shown.
•
If connecting using 223.0.0.1 takes a long time, configure a static IP address for the PC.
Internet Connection:
You can connect to the PBX in On-line mode using the Off-line Web Maintenance Console Programme
Launcher. For details, see Connecting in On-line Mode using the Programme Launcher in 1.2.2 PC
Programming Using Off-line Mode.
3. The Web Maintenance Console login screen is displayed. For details about logging in, see
2.1.3 Logging in to Web Maintenance Console.
•
If this is the first time the PBX is accessed (i.e., it is in its initialised, factory default state), you must
log in using the Installer level account. Once you log in, the Easy Setup Wizard will launch. For
details, see 2.1.4 Easy Setup Wizard.
•
If the PBX has been set up using the Easy Setup Wizard, PBX system programming can be
performed. To perform programming, enter the login name and password according to your status
and authorisation level. For details about the differences between levels of authorisation, see
2.1.1 Web Maintenance Console Accounts.
4. After you successfully log in to Web Maintenance Console, the Home screen will be displayed and
programming can be performed. For details about accessing the different features of Web Maintenance
Console, see 3.1 Home Screen.
Connecting to Web Maintenance Console (Remote Access)
Below is the procedure for connecting to Web Maintenance Console to programme via Remote Access:
1.
Connect the PC to the PBX.
•
Install the Remote card, connect the PBX to an analogue line, and access the PBX from a PC via a
remote modem.
•
Connect the PBX to an ISDN line and access the PBX from a PC via an ISDN modem.
For more details, refer to "5.2 PC Connection—Connection via RMT Card (KX-TDA0196)" or "5.2 PC
Connection—Connection via PRI23 Card (KX-NS5290), PRI30/E1 Card (KX-NS5290CE), BRI2 Card
(KX-NS5282), or BRI4 Card (KX-NS5284)" in the Installation Manual.
2. Start the Off-line Web Maintenance launcher :
Analogue Line connection:
1) Click the Connect-Online Mode button.
2) Select the Modem tab.
3) Set the following:
– Dial Number / Dial Type / Port / Baud Rate (bps) / Flow Control / Command
4) Enter the Password.
5) Click the Connect button.
ISDN Line connection:
1) Click the Connect-Online Mode button.
2) Select the ISDN Remote tab.
3) Enter the Telephone Number.
4) Enter the Password.
5) Click the Connect button.
3. The Web Maintenance Console login screen is displayed. For details about logging in, see
2.1.3 Logging in to Web Maintenance Console.
28 PC Programming Manual