Panasonic KX-NS300 Pc Programming Manual page 256

9.21 PBX Configuration—[1-1] Configuration—Slot—Card Property—Extension Type
9.21 PBX Configuration—[1-1] Configuration—Slot
—Card Property—Extension Type
The property for the extension cards can be specified.
Name
SLT Pulse Dial
Mode
SLT Off Hook
Time
SLT Off Hook
Guard Time
SLT Pulse
Maximum Break
Width
SLT Pulse
Minimum Make
Width
SLT Flash
Detection
Flash Timing -
Min.
Flash Timing -
Range
DTMF-R STD
Detection Time
SLT Power
Supply
256 PC Programming Manual
Description
Selects the type of pulse dial
transmission appropriate to your area.
Specifies the minimum length that a
pulse dial sent from an SLT must be for
the PBX to recognise it as an off-hook
signal.
Specifies the length of guard time used
for off-hook signals from SLTs, to prevent
the PBX mistaking them for pulse dials.
Specifies the maximum length of the
break signal in a pulse dial.
Specifies the minimum length of the
make signal in a pulse dial.
Enables the PBX to detect the flash
signal sent when an SLT user presses
the hookswitch or the Flash/Recall
button.
Specifies the minimum length that a
signal sent from an SLT must be for the
PBX to recognise it as a hookswitch
flash signal.
Specifies the maximum length that a
signal sent from an SLT can be for the
PBX to recognise it as a hookswitch
flash signal.
Specifies the minimum length that a
DTMF tone must be for the PBX to
recognise it as a DTMF tone.
Selects the voltage that enables an SLT
to activate the Message Waiting lamp.
When an MCSLC card is installed, the
value for this setting is fixed at "85 V".
Value Range
Normal, Sweden, New
Zealand
8 × n (n=3–255) ms
8 × n (n=12–63) ms
8 × n (n=9–20) ms
8 × n (n=1–5) ms
Disable: The PBX
disconnects the line to
prevent placing the
call on hold.
Enable: The PBX
places the call on
consultation hold.
8 × n (n=3–63) ms
8 × n (n=3–191) ms
2 × n (n=1–31) ms
85 V, 145 V
Links
Feature
Manual
References
2.13.3 Call
Splitting
Feature
Manual
References
2.20.1
Message
Waiting