Panasonic KX-NS300 Pc Programming Manual page 167

Name
Maximum Bit Specifies the maximum bit rate of the fax
Rate signal.
FAX Enables the use of the FAX Detection
Detection Ability feature. Since fax signals using a
Ability codec other than G.711 cannot be
received accurately at the destination,
this feature automatically switches the
codec to G.711 to enable end-to-end fax
signal relay over the network.
DTMF Specifies the method to transport DTMF
tones.
Payload Type Specifies the payload type for DTMF
tones using RFC2833. Programming this
parameter is only necessary if DTMF is
set to Outband (RFC2833).
V-IPGW–GW Settings–Option 3
Name
GW Name
T38 FAX Max Datagram
T38 FAX UDPTL Error
Correction – Redundancy
T38 FAX UDPTL
Redundancy count for T.30
messages
T38 FAX UDPTL
Redundancy count for data
T38 FAX Rate Management
Method
V-IPGW–DN2IP
Name
Leading Number
9.2.1 PBX Configuration—[1-1] Configuration—Slot—System Property—Main
Description
Specifies the name of the destination
gateway device for programming reference.
Specifies the maximum datagram size when
using the T.38 protocol.
Specifies whether to enable the redundancy
feature when using the T.38 protocol.
Specifies the redundancy count for T.30
messages when using the T.38 protocol.
Specifies the redundancy count for data
when using the T.38 protocol.
Specifies the rate management method
when using the T.38 protocol.
Description
Specifies the leading digits in dialled numbers by which
to associate calls with the appropriate destination.
Value Range
No Speed Limit,
2400 bps, 4800
bps, 7200 bps,
9600 bps, 12000
bps, 14400 bps
Disable, Enable
Inband, Outband
(RFC2833),
Outband (H.245)
96–127
Description
Links
PC Programming
Manual
References
9.2.1 PBX
Configuration—[1-1]
Configuration—Slot—
System Property—
Main—V-IPGW–GW
Settings–Option 1—IP
Codec Priority—1st,
2nd, 3rd
Value Range Links
Max. 20
characters
272–512
Disable, Enable
0–7
0–3
Transferred TCF,
Local TCF
Value Range Links
Max. 30 digits
(consisting of 0–9)
PC Programming Manual 167