Panasonic KX-NS300 Pc Programming Manual page 249

9.20 PBX Configuration—[1-1] Configuration—Slot
—Port Property—V-UTEXT
Various settings can be programmed for the ports of V-UTEXT cards.
KX-UT Series SIP Phone, S-PS, and SIP-CS Registration and De-registration
A KX-UT series SIP phone, S-PS, or SIP-CS must be registered to the PBX by programming the PBX and
SIP phone, S-PS, or SIP-CS before it can be used.
Programming instructions for the PBX are given below.
It is possible to de-register the SIP phone, S-PS, or SIP-CS later.
Registration, De-registration, and Forced De-registration can be performed only in On-line mode.
Name
Preparation Open 27.1 Network Service—[1] IP Address/Ports—Basic Settings,
and confirm that the IP addresses of the mother board and DSP card,
subnet mask address, and default gateway address are set.
Registration Follow the steps below to register a SIP phone.
1.
2.
3.
4.
5.
Note
9.20 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-UTEXT
Connect the device to be registered to the network and, if
necessary, the power supply.
Click Registration.
A dialogue box will appear. Non-registered (available) extension
numbers and names are displayed on the left.
Highlight numbers and names and click the right arrow to select
them for registration. Click Next.
Click Next.
If the registration is still in progress, the dialogue box will show
"Registration Executing".
If the registration is successful, the dialogue box will show
"Registration Completed". Click Close.
Once the device is successfully registered, the status of the device
will update to show "Registered".
S-PSs and SIP-CSs will be automatically registered to the PBX
after settings have been made via CS web programming for the
Super Master CS. For details, refer to the documentation for the
SIP-CS.
Description
Value
Links
Range
PC Programming Manual 249