Panasonic KX-NS300 Pc Programming Manual page 242

9.17 PBX Configuration—[1-1] Configuration—Slot—Card Property—V-IPCS
9.17 PBX Configuration—[1-1] Configuration—Slot
—Card Property—V-IPCS
The properties of the V-IPCS card can be specified.
Name
Signalling
(PTAP) UDP
Port No.
(Server)
Signalling
(MGCP) UDP
Port No.
(Server)
Signalling
(MGCP) UDP
Port No. (IP-
CS)
Voice (RTP)
UDP Port No.
(IP-CS)
Keep Alive
Time-Out
First Resending
Time (PTAP)
242 PC Programming Manual
Specifies the UDP port used by the V-IPCS card to transmit and
receive PTAP (Panasonic Telephony Administration Protocol)
data. This must be changed if another network application is
using the same port.
To change the value displayed here, click Common Settings
and set the desired value.
Specifies the UDP port used by the V-IPCS card to transmit and
receive MGCP (Media Gateway Control Protocol) data. This
must be changed if another network application is using the
same port.
To change the value displayed here, click Common Settings
and set the desired value.
Indicates the UDP port used to transmit and receive MGCP
(Media Gateway Control Protocol) data on the IP-CS side
(reference only).
Specifies the UDP port used to transmit and receive RTP (Real-
time Transfer Protocol) data on the IP-CS side. This must be
changed if another network application is using the same port.
For voice communications, an IP-CS uses 128 contiguous UDP
ports, starting from the port number specified here.
To change the value displayed here, click Common Settings
and set the desired value.
Specifies the length of time that the PBX will continue to
consider an IP-CS to be active even if it receives no
transmissions from that IP-CS. The PBX constantly confirms the
status of IP-CSs. If no communications are received from an
IP-CS for the duration specified here, the PBX considers the
IP-CS to be unreachable, and sets the port status to Fault.
During operation, set between 10 s and 60 s. Settings over 60
s, and Disable, are used for debugging purposes, and IP-CSs
cannot be guaranteed to function normally in these
circumstances. Do not use debugging settings unless instructed
to do so.
To change the value displayed here, click Common Settings
and set the desired value.
Specifies the length of time that the PBX waits before starting to
resend PTAP (Panasonic Telephony Administration Protocol)
data.
To change the value displayed here, click Common Settings
and set the desired value.
Description
Value
Links
Range
1024–
65535
1024–
65535
2427
1024–
65024
Disable,
10–120 s
500 × n
(n=1–16)
ms