Panasonic KX-NS300 Pc Programming Manual page 115

–
1: Main Unit
–
2: Expansion Unit1
–
3: Expansion Unit2
–
4: Expansion Unit3
•
Y: Slot number (1-7)
2. From the Interval Timer drop-down list, select the number of seconds between each automatic screen
refresh.
3. Click Start.
Monitoring will be performed and the screen will refresh according to the interval specified.
4. Click Stop to end monitoring.
To refresh the screen at any time while monitoring is stopped, click Refresh.
7.4.8 Utility—Monitor/Trace—E1 Line Trace
Traces the sent and received signalling bits and dial numbers on the specified channel of the E1 line card.
This utility is intended for use by dealers.
For information about Expansion Units, see 9.33 PBX Configuration—[1-1] Configuration—Slot—
Expansion Unit1/Expansion Unit2/Expansion Unit3.
This option is only available at Installer level, and requires that the target card be set to INS status.
To view trace data
1. From the Shelf-Slot No. drop-down list, select the target slot. Each card will be preceded by the pattern
"X-Y" as follows:
•
X: Shelf number (1-4)
–
1: Main Unit
–
2: Expansion Unit1
–
3: Expansion Unit2
–
4: Expansion Unit3
•
Y: Slot number (1-7)
2. From the CH No drop-down list, select the target channel.
3. Click Start.
Trace information will be displayed. The information is automatically updated whenever the data being
monitored changes.
4. Click Stop to end the trace.
5. Select an option:
•
Click Capture to save the displayed trace information.
Information will be saved to the PC as a text-format file.
•
Click Clear to erase the information.
7.4.9 Utility—Monitor/Trace—TCP Trace
The TCP trace result of LAN port transmission activity can be output to the USB port.
You must log in using the Installer level account to use this feature.
You must access the TCP trace output destination device directly from the Web Maintenance Console when
using this feature. In a One-look network, you cannot access this feature via the Master PBX's Web
Maintenance Console.
7.4.8 Utility—Monitor/Trace—E1 Line Trace
PC Programming Manual 115