Panasonic KX-NS300 Pc Programming Manual page 266

9.24 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
9.24 PBX Configuration—[1-1] Configuration—Slot
—Port Property - LCO Port
Various settings can be programmed for each analogue trunk port.
The Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
Name
Port Type Select to use the port with either the
CO, MOH, or External Pager
features. (Only LCOT6 is installed by
default.)
2 ports, an odd and an even port, are
programmed in a pair.
Connection Indicates the port status. To change
the status of the port, click the
desired cell in the column, and then
select INS or OUS for the port.
This option is only available in On-
line mode.
This option can only be changed
when CO is selected for the Port
Type.
Busy Out Indicates the Busy Out status
Status (reference only).
Dialling Mode Selects the type of signal used to dial
out to the analogue trunk.
CPC Signal Specifies the length of time required
Detection by the PBX to detect a CPC signal on
Time— outgoing or incoming trunk calls
Outgoing, before disconnecting the line. When
Incoming None is selected here, the line will
not be disconnected when a CPC
signal is not detected.
DTMF Width Selects the length of the DTMF tone
sent to the analogue trunk.
Pulse Speed Selects the speed at which pulse
dials are sent to the analogue trunk.
266 PC Programming Manual
Description Value Range
CO, MOH, Installation Manual
External Pager
References
4.3.4 LCOT6 in KX-NS300
(installed by default)
INS: The port is in
service.
OUS: The port is
out of service.
Normal, Busy Out Feature Manual
References
2.5.4.6 Trunk Busy Out
DTMF, Pulse Feature Manual
References
2.5.4.4 Dial Type Selection
None, 6.5 ms, 8 × Feature Manual
n (n=1–112) ms
References
2.11.9 Calling Party
Control (CPC) Signal
Detection
80 ms, 160 ms
Low, High
Links