Panasonic KX-NS300 Pc Programming Manual page 49

A •
It is not possible to use the same number for 2 items.
The number you are trying to store cannot be used if it is already being used by:
–
A feature number
–
An extension
–
A Dial setting (see 17.1 PBX Configuration—[9-1] Private Network—TIE Table)
–
Quick Dialling (see 10.6.2 PBX Configuration—[2-6-2] System—Numbering Plan—Quick
Dial)
In any of these cases, choose another number.
Q I cannot change a feature number on the B/NA DND Call Feature screen.
A •
The number you are trying to store is already being used by another call feature.
Please choose a different number.
Q How do I prevent extension numbers being automatically assigned to a newly installed card?
A •
Change New Card Installation—Automatic Extension Number Set for Extension Card in the
9.36 PBX Configuration—[1-3] Configuration—Option screen from "Enable" to "Disable".
Saving Modified Data
Q Modified settings have not been updated in the PBX.
A •
Click Apply or OK in the main screen.
Q If I reset the PBX directly after modifying settings, the modified settings are not updated in
the PBX.
A •
When you click Apply, the settings are updated in the PBX, but are not yet saved to the System
Memory. If system data is not saved to the System Memory, the PBX will restore the data that
was last saved to the card in the event that the PBX is reset, or power is turned off and back on
again.
Therefore, before resetting the PBX, click the
data to the System Memory. Also, when you finish a programming session, be sure to click the
button to logout and save the system data to the System Memory.
Q After reinitialising the PBX, I restored system data from a previous backup.
However, some of the settings have not been restored to their previous values.
A •
The following setting data is not saved to the System Memory, so will be deleted when the PBX is
initialised. This data is stored in the PBX's battery backup memory.
–
Advice of Charge (AOC)
–
Hospitality guest billing data
–
Timed Reminder
–
ICD Group login status
(All extensions are set to Login by default.)
–
Remote Extension Dial Lock
Setting Features
Q How do I change the dialling mode of an analogue trunk?
2.3 Frequently Asked Questions (FAQ)
button on the Home screen to save the system
PC Programming Manual 49