Panasonic KX-NS300 Pc Programming Manual page 215

Name
Connection
T38 FAX Max
Datagram
T38 FAX UDPTL
Error Correction –
Redundancy
T38 FAX UDPTL
Redundancy count for
T.30 messages
T38 FAX UDPTL
Redundancy count for
data
T38 FAX Rate
Management Method
Reject T.38 Request
from Network
T.38 FAX NAT
Traversal
T.38 Option
The Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
Name
Connection
T38 FAX QoS
Available
T38 FAX
QoS-ToS Priority
T38 FAX
QoS-ToS Type
9.10 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-SIPGW
Description
Indicates the port status. To change the
status of the port, click the desired cell in
the column, and then select INS or OUS
for the port.
This option is only available in On-line
mode.
Specifies the maximum datagram size
when using the T.38 protocol.
Specifies whether to enable the
redundancy feature when using the T.38
protocol.
Specifies the redundancy count for T.30
messages when using the T.38 protocol.
Specifies the redundancy count for data
when using the T.38 protocol.
Specifies the rate management method
when using the T.38 protocol.
Specifies whether T.38 protocol data
requests are rejected or accepted.
Specifies the NAT Traversal packet type
when sending or receiving faxes using the
T.38 protocol.
Description
Indicates the port status. To change the status of
the port, click the desired cell in the column, and
then select INS or OUS for the port.
This option is only available in On-line mode.
Specifies the type of value to be stored in the
ToS field in the IP header when using the T.38
protocol.
Specifies the priority level in the ToS field when
using the T.38 protocol.
Specifies the ToS type in the ToS field when
using the T.38 protocol.
Value Range
INS: The port is in
service.
OUS: The port is out of
service.
Fault: The port is not
communicating with the
network.
272–512
Disable, Enable
0–7
0–3
Transferred TCF, Local
TCF
Disable, Enable
Disable, Blank UDP
Value Range
INS: The port is in
service.
OUS: The port is out of
service.
Fault: The port is not
communicating with the
network.
ToS, DSCP, HEX
0–7
Normal, Monetary Cost,
Reliability, Throughput,
Delay
PC Programming Manual
Links
Links
215