Panasonic KX-NS300 Pc Programming Manual page 465

Name
Keep ring after
FWD NA to CO
Remote FWD
COS
12.2.1.1 PBX Configuration—[4-2-1] Extension—Portable Station—
Extension Settings—CLIP Generate
CLIP Generate allows the CLIP numbers for a set of locations in series to be programmed together. Pre-
assigned CLIP numbers for those locations will be overwritten.
If a number generated here is longer than 16 digits, the additional digits will be discarded.
Name
Location Entry
—Beginning
Entry Location
(Ext. Number)
Location Entry
—Number to
Generate
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings
Description
Specifies whether a PS
continues to ring after
forwarding an incoming
call to an outside
destination via FWD N/A
or FWD Busy N/A.
Specifies the COS that
allows the FWD setting on
the extension to be
changed from another
extension. This COS must
then be set for the
extensions that will
remotely change the FWD
setting.
Description
Specifies the extension
number of the first location
to be programmed.
Specifies the number of
locations to be
programmed.
A CLIP number will only be
assigned to registered PS
extensions, even if the
number entered here is
larger than the total number
of PS extensions.
Value Range
Disable, Enable PC Programming Manual
References
12.2.2 PBX Configuration—[4-2-2]
Extension—Portable Station—
FWD/DND
Feature Manual References
2.3.2 Call Forwarding (FWD)
Disable, 1–64 Feature Manual References
2.3.2 Call Forwarding (FWD)
Value Range
PC Programming Manual
PS extension
number
References
12.2.1 PBX Configuration—[4-2-1]
Extension—Portable Station—
Extension Settings
Feature Manual References
4.1.2.2 Calling/Connected Line
Identification Presentation (CLIP/
COLP)
PC Programming Manual
1–total number
of connected
References
PS extensions
12.2.1 PBX Configuration—[4-2-1]
Extension—Portable Station—
Extension Settings
Feature Manual References
4.1.2.2 Calling/Connected Line
Identification Presentation (CLIP/
COLP)
Links
Links
PC Programming Manual 465