CPS REPLACEMENT
1. Lift the rear cargo box to raised position.
2. Disconnect the CPS harness connector
3. Remove CPS wire lead from wire clip
4. Remove CPS retaining fastener
sensor from the stator cover.
5. Install new sensor using a light coating of oil on the
O-ring to aid installation.
6. Torque CPS retaining fastener to specification.
TORQUE
CPS Retaining Fastener:
9 ft-lbs (12 Nm)
7. Route CPS wire lead through wire clip
reconnect CPS harness connector
NOTICE
Make sure CPS harness connector standoff
properly secured.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
q
.
e
.
w
and remove the
e
and
q
.
r
remains
ENGINE ELECTRICAL
4.11
4