Timing Chain Cover Cleaning And Inspection; 2Nd Timing Chain And Chain Tensioner Components - Suzuki Grand Vitara 2011 Manual

1D-86 Engine Mechanical: For J20 Engine
10) Install crankshaft pulley. To lock crankshaft pulley
(1), use special tool (camshaft pulley holder) as
shown in figure.
Special tool
(A): 09917–68221
NOTE
Be sure to use the following bolts instead of
pins in order to fix crank pulley by special
tool.
Bolt size: M8, P1.25 L = 25 mm (0.98 in.)
Strength: 7T
Tightening torque
Crankshaft pulley bolt (a): 150 N·m (15.0 kgf-m,
108.5 lb-ft)
2. Bolt

2nd Timing Chain and Chain Tensioner Components

8 (a)
7
1. 2nd timing chain
: Apply engine oil
2. Timing chain tensioner adjuster No.2
: Apply engine oil to sliding surface.
3. Tensioner adjuster No.2 gasket
I2RH01140060-01
3. Wrench
4
9
3
5
1
9
6
(b)
2
(c)
6. Camshaft timing sprocket bolt
7. Timing chain tensioner adjuster No.2 nut
8. Timing chain tensioner adjuster No.2 bolt
11) Install engine assembly to vehicle referring to
"Engine Assembly Removal and Installation: For J20
Engine".

Timing Chain Cover Cleaning and Inspection

Clean
Clean sealing surface on timing chain cover, crank case,
cylinder block and cylinder head.
Remove oil, old sealant, and dust from sealing surface.
Inspection
Check oil seal lip for fault or other damage. Replace as
necessary.
10
S6JB0A1426014
S6JB0A1426015
I5JB0A142023-02
: 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
: 80 N⋅m (8.0 kgf-m, 58.0 lb-ft)
: 45 N⋅m (4.5 kgf-m, 32.5 lb-ft)