Water Pump Removal And Installation (For M16 Engine Model); Water Pump Removal And Installation (For J20 Engine Model) - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:
Table of Contents

Advertisement

Water Pump Removal and Installation (For M16
Engine Model)
Removal
1) Disconnect negative cable at battery.
2) Drain coolant.
3) Remove water pump and generator drive belt
referring to "Water Pump and Generator Drive Belt
Removal and Installation (For M16 Engine): For
Petrol Engine Model in Section 1J".
4) Remove water pump assembly (1).
Installation
1) Apply sealant to mating surface of water pump (1) as
shown in the figure.
"A": Water tight sealant 99000–31250 (SUZUKI
Bond No.1207F)
Sealant quantity (to mating surface of water
pump)
Width "a": 3 mm (0.12 in.)
Height "b": 2 mm (0.08 in.)
Engine Cooling System: For Petrol Engine Model 1F-12
2) Install water pump assembly (1) to cylinder block
and tighten bolts and nut to specified torque.
S6JB0A1616015
Tightening torque
Water pump bolt and nut (a): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
3) Install water pump pulley.
4) Install water pump and generator drive belt referring
to "Water Pump and Generator Drive Belt Removal
and Installation (For M16 Engine): For Petrol Engine
Model in Section 1J".
I2RH0B160016-01
5) Install P/S pump and A/C compressor drive belt (if
equipped) referring to "P/S Pump and A/C
Compressor (If Equipped) Drive Belt Removal and
Installation (M16A Engine Model) in Section 6C".
6) Refill cooling system referring to Step 7) to 17) of
"Cooling System Flush and Refill: For Petrol Engine
Model".
7) Connect negative cable at battery.
8) Check each part for leakage.
Water Pump Removal and Installation (For J20
Engine Model)
Removal
1) Disconnect negative cable at battery.
2) Drain coolant referring to "Cooling System Draining:
For Petrol Engine Model".
3) Remove water pump and generator drive belt
referring to "Water Pump and Generator Drive Belt
Removal and Installation (For J20 Engine): For
I3RM0A160016-01
Petrol Engine Model in Section 1J".
4) Remove thermostat referring to "Thermostat
Removal and Installation (For J20 Engine Model):
For Petrol Engine Model".
I2RH0B160018-01
S6JB0A1616016

Advertisement

Table of Contents
loading

Table of Contents