Suzuki Grand Vitara 2011 Manual page 920

2C-27 Rear Suspension:
5) Support lower arm with jack.
6) Loosen control rod outer bolt, trailing rod rear bolt
and lower arm outer bolt referring to the figure in
"Rod and Arm Components".
7) Disconnect upper arm joint from rear suspension
knuckle (1) with puller (2) and remove rear
suspension knuckle.
NOTE
Do not remove upper arm joint nut (3) to
avoid the rear suspension knuckle fall off.
3
1
Installation
1) Connect upper arm joint (2) to rear suspension
knuckle (1).
2) Tighten new upper arm joint nut (3) to specified
torque.
CAUTION
!
Do not reuse removed upper arm joint nut.
Tightening torque
Upper arm joint nut (a): 55 N·m (5.5 kgf-m, 40.0
lb-ft)
2
1
2
I5JB0A230072-01
3,(a)
I5JB0A230073-01
3) Install lower arm, trailing rod and control rod to rear
suspension knuckle referring to the figure in "Rod
and Arm Components" and tighten bolts temporarily
by hand.
CAUTION
!
If reuse lower arm outer bolt, trailing rod rear
bolt and control rod outer bolt, apply engine
oil to thread, bearing and trunk surface.
4) Remove floor jack from lower arm.
5) Install rear brake hose bracket (1) and then tighten
rear brake hose bracket bolt (2) to specified torque.
Tightening torque
Rear brake hose bracket bolt (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
1
6) Install wheel speed sensor (1) and then tighten
wheel speed sensor bolt (2) to specified torque.
Tightening torque
Wheel speed sensor bolt (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
1
2,(a)
2,(a)
I5JB0A230074-01
I5JB0A230075-01