Specifications; Starting Motor Specifications; Tightening Torque Specifications - Suzuki Grand Vitara 2011 Manual

1I-18 Starting System: For Diesel Engine Model
Hold-in coil open circuit test
Check for continuity across magnetic switch "S" terminal
and coil case. If no continuity exists, coil is open and
should be replaced.

Starting Motor Specifications

Voltage
Output
Rating
Direction of rotation
Number of pinion teeth
Performance
No load characteristic
Around Load characteristic
at 20 °C (68 °F)
Locked characteristic
Magnetic switch operating voltage

Tightening Torque Specifications

NOTE
The specified tightening torque is also described in the following.
"Starting Motor Dismounting and Remounting: For Diesel Engine Model"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information in Section 0A".
Pinion and Over-Running Clutch
• Inspect pinion for wear, damage or other abnormal
conditions. Check that clutch locks up when turned in
direction of drive and rotates smoothly in reverse
direction. Replace if necessary.
I5JB0B190021-02
• Inspect spline teeth for wear or damage. Replace if
necessary. Inspect pinion for smooth movement.

Specifications

12 volts
2.2kW
30 seconds
Clockwise as viewed from pinion side
11
Condition
90 A maximum
11.0 V
2400 rpm minimum
7.5 V 10.8 N⋅m (1.1 kg-m, 7.8 lb-ft) minimum
300 A 870 rpm minimum
840 A maximum
3.0 V
19.8 N⋅m (2.0 kg-m, 14.3 lb-ft) minimum
8 volts maximum
I5JB0B190022-01
I5JB0B190023-01
S6JB0A1927001
Guarantee
S6JB0A1927002