Dtc P0830: Cpp Switch Circuit - Suzuki Grand Vitara 2011 Manual

1A-343 Engine General Information and Diagnosis: For Diesel Engine Model

DTC P0830: CPP Switch Circuit

CAUTION
!
• This fault may appear if the wiring harness has been damaged.
Follow the procedure described in "Electrical Circuit Inspection Procedure in Section 00".
• This check enables the condition and the conformity of the engine wiring harness to be checked.
NOTE
• Conditions for applying the fault finding procedure to stored faults:
The fault is declared present after the clutch pedal is depressed, or during a road test.
• If this fault is present, the cruise control / speed limiter function will be inhibited.
• Use service wire for all operations on the ECM connectors.
Wiring Diagram
For wiring circuit and connector number, refer to "A-5 Engine and A/C Control System Circuit Diagram (DSL) in
Section 9A".
Detecting Condition
Displaying on SUZUKI scan tool
D1
D2
Troubleshooting
Check the condition and adjustment of the clutch pedal position (CPP) switch.
Repair if necessary.
If these checks are correct:
• Check the connections of the clutch pedal switch.
• Check the ECM connections.
Repair if necessary.
Check continuity and make sure there is no interference resistance on the following connection:
• Between "E71-2" wire of clutch pedal switch connector and "E66-30" terminal of ECM connector.
Repair if necessary.
Check for the presence of ground on "E71-1" wire of the clutch pedal switch.
Repair if necessary.
If the fault is still present, substitute a known-good ECM and recheck.
Detecting condition
Signal absent
Inconsistency of signal
S6JB0A1124131